整站优化,优大师,中国影响力,小程序开发,微信定制  整站优化,优大师,中国影响力,小程序开发,微信定制
整站优化,优大师,中国影响力,小程序开发,微信定制

常州武鼎地毯机械有限公司Changzhou Wuding Carpet Machinery Co。, Ltd。

 

Contacts:Mr. Gu

 

Phone:86-0519-86350156

 

Mobile:13916563656

 

Fax:86-0519-86350156

 

Zip code:213000

 

Address:No。 10, Longting Road, High-tech Development Zone, Wujin District, Changzhou City



News Center

Your Current Location:Home > News Information > 详细内容
Concretely speaking construction scheme
2018-07-03

Concretely speaking the construction scheme of artificial turf

1. before the construction of artificial grass products, it is necessary to test the evenness, slope and surface perception of the ground base, and the error of the evenness should not exceed the 3M ruler 3mm. The drainage slope of the site should not be less than 0.7% according to the climate characteristics of more precipitation in Changzhou, for example, the leveling and the slope can not reach the above indexes. To rectify the site foundation, only after reaching the above requirements can the construction be carried out.

2. line, find the center of the site and two semicircle centers, and according to the three location point drawing line, set out the center line and the border intersection point, and then the Pythagorean theorem to determine the exact location of the corner, point, line, and then determine the position of the function points and lines; and the use of ink line or lacquer line.
3. spread the SOD in the direction of a border, and ensure that the white lines in the A1 rolls are consistent with the bottom line, and then the curls are pushed from one end to the other. At the same time, it is necessary to ensure that the white lines in the A14 or A15 rolls are consistent with the middle line, so that the white lines in the A28 curls are consistent with the other line. In the process of spreading turf, reduce wrinkles as far as possible.
4. the other part of the white weave must be cut by hand into a width of 120mm white line, placed aside for use.
5. connect the seams of green turf to 2-3 centimeters, cut through the center of the lap joint with a cutting blade, make the SOD on both sides as close as possible, and then trim it with a paper cutter.
6. open the joint with 20 or 30 centimeters wide along the seams of the turf, put it under the turf, make the seams of the turf in the center of the connecting belt as much as possible, and then apply the rubber scraper evenly to the connecting belt, then combine the two sides of the turf, glue it on the connecting belt, and beat with a rubber hammer to make a combination part. The bonding is tight. If the gap is larger after straightening, it can be cut off at 2-5 cm apart and stretched to the interface to ensure the beautiful appearance.
Copyright 2017 Changzhou Wuding Carpet Machinery Co., Ltd. All rights reserved  |  Sitemap   |  常州武鼎地毯机械有限公司RSS subscription
Company address:No. 10, Longting Road, High-tech Development Zone, Wujin District, Changzhou City Phone:86-0519-86350156 Mobile:13916563656 
Record number:  |  Technical Support:|  Backstage login